ACO FAM-P, Инструкция пользователя, Страница: 39 / 41

- 39 -
XII. INSTALLING THE BUTTON FOR ADDITIONAL INPUT
The panel features an additional input which, depending on the settings, can be used for direct
activation of the ELOCK output or for direct calling to a selected uniphone address.
A normally open (NO) monostable pushbutton is connected to its terminals. When the button is short-
circuited, the corresponding function is called up.
The panel features input protection against permanent short circuit. In case of a button failure and
its permanent short-circuit, the panel will perform the active function only once. Only after removing
the short circuit, the panel will again respond to the input status.
XIII. RESTORING FACTORY SETTINGS OF THE PANEL
Turn the panel power supply off, wait 5 seconds, turn the power on again. The panel will beep
for 30 seconds. Press the "#" button during this time and press at the same time (immediately) press:
- keys 1 and 7 to restore the lower key code to 1111
- keys 2 and 7 to restore the second key code to 2222
- keys 2, 5, 8 to restore all factory settings, including both codes, and to delete all the proximity fobs
from the memory
-
keys 1, 4, 7 to disable the “Call only buttons" and "Codes without a key" functions (the Familio panel
will operate as usually like, for instance CDNP/INSPIRO, i.e. calls can be made directly from the
numeric keypad, and the codes must be preceded by the apartment number and the button) of the
button.
Once the factory settings are successfully restored (or settings changed), the panel will generate an
appropriate audible signal, which may last for a long moment (stop pressing the keys and wait for
the signal to finish).
For models without numeric keypad, turn off the panel power, wait for 5 seconds, turn on the
power again, after the first beep, press and hold the lower direct call button until the factory settings
restore procedure is launched (the panel will start beeping - stop pressing the key and wait for the
signal to finish).
Restoring the factory settings is only possible when the software is not locked ("Reset
possible").
XIV. FACTORY SETTINGS

The direct call buttons select physical addresses, respectively, from the bottom:
between 1 and 6

Code table with the default or most recently entered number (only FAM-P-ZS and FAM-PV-
ZS)

Installer’s password "1507 0000"

No administrator code 1 and 2

No call offset (offset = 0)

Calling possible only from direct call buttons (except FAM-P-ZS and
FAM-PV-ZS)

Range of supported apartments from 1 to 10 (only FAM-P-xNPZS, FAM-PV-xNPZS, FAM-P-
ZS, FAM-PV-ZS)

Range of supported apartments from 1 to 150 (only FAM-P-xNP and FAM-PV-xNP)

Call volume for all apartments - level 2

Ringtone for all apartments - No. 3

The number of ringing signals for all apartments - 2