ACO FAM-P, Инструкция пользователя, Страница: 32 / 41

- 32 -
All panel settings are stored in permanent memory and are not lost when the power is turned
off. Panels without numeric keypad (code lock) can only be programmed via a PC.
To enter service menu (panel settings programming mode) on panels with numeric keypad,
press the " key " button and enter the eight-digit password: "1507xxxx". The first four digits of the
password “1507” are a fixed digits and the following digits "xxxx" are the four-digit installer’s
password (by default 0000). Entering the settings programming mode is confirmed by an up-
modulated sound. Programming mode activity time is limited to 10s counting from the last change.
Use the "
# " button to exit the programming mode.
The installer’s password is set to "0000" by default and must be changed after installation!
(Program No. 7).
After entering the service menu, enter the program number (from 0 to 9) that corresponds to
relevant settings. After entering the program number, the panel counts down the appropriate number
of short beeps (depending on the program number) and confirms entering the relevant program with
a short up-modulated beep. To stop programming at any time and exit the program, press the "
# "
button - the changes will not be saved then.
EXAMPLE:
To enter the panel programming function with 0000 installer’s code, press the "
key " followed by
1507 (fixed digits) and 0000.
1 5 0 7 0 0 0 0
Entering the programming mode is confirmed by an up-modulated sound. After this step, enter the
number of the desired program.
The following programs are available
on the panel:
0 - SERVICE DOOR OPENING
Select program "0" to start door opening (for a pre-set time) and automatically exit the
programming function. This program also disables (if enabled in program 6) the function of service
calling of the receiver in apartment.
1 - ACCESS CODE CHANGE (RESIDENT, ADMINISTRATOR)
The code can be used for door opening (for instance to activate E-lock ) or to activate another
device connected to the ELOCK output (for instance via the CDN-PK relay module); it can also be
used, upon pressing the “key” button twice, to activate the relay output of the I/O MINI module (for
instance to open gate 2).
Note! By default, panels, except those with numeric keypad only, are set to simplified code
changing mode - see chapter III - USING THE PANEL
For versions with only a numeric keypad (or after changing the default settings), use the method
described below.
Modification of user’s access code
Changing the code of apartment 9 to 4256: Enter 9 as apartment number, confirm with the "key"
button, and then enter the four digits of the new code in sequence. It will be stored in the memory for
apartment No. 9.