2. LED:
POWER
ON
Power On
DMX
ON
DMX input present
3. Button:
MENU
To enter into move backward or leave the menu
DOWN
To go forward in the selected functions
UP
To go backward in the selected functions
ENTER
To confirm the selected functions
4. DMX IN:
DMX512 link, use 3/5-pin XLR cable to link the unit and the DMX controller to input DMX signal
5. DMX OUT:
DMX512 link, use 3/5-pin XLR cable to link the next unit to output DMX signal
6. MAINS IN:
To connect to the mains supply
7. MAIS OUT:
To connect to the next unit
8. Fuse (T 6.3A):
Protects the unit from over-voltage or short circuit
3.2 Main Function
To select any of the given functions, press the MENU button until the required function is showing
on the display. Select the function by pressing the ENTER button and the display will blink. Use the
DOWN/UP buttons to change the mode. Once the required mode has been selected, press the
ENTER button to setup, to go back to the functions without any change press the MENU button
again. Press and hold the MENU button for about one second or wait for one minute to exit the
menu mode.
The main functions are shown overleaf:
6H
