ACME FARANDOLE AM-BAR, Руководство пользователя, Страница: 12 / 16

5.2 Address Setting
If you use a universal DMX controller to control the units, you have to set DMX address from 1 to 512
so that the units can receive DMX signal.
Press the MENU button to enter menu mode, select DMX Functions , press the ENTER button to
confirm, use the UP/DOWN button to select DMX Address , press the ENTER button to confirm, the
present address will blinking the display, use the UP/DOWN button to adjust the address from 001 to
512, press the ENTER button to store. Press the MENU button back to the last menu or idling let the
unit idle one minute to exit menu mode.
Please refer to the following diagram to address your DMX512 channel for the first 4 units.
Channel mode
Unit 1
Address
Unit 2
Address
Unit 3
Address
Unit 4
Address
6 channels 1 7 13 19
9 channels 1 10 19 28
5.3 DMX 512 Configuration
Please refer to below configurations to control the fixtures
Attentions:
1. The unit will maintain the last condition until reset if you cut-off the DMX signal.
2. For the channel Function, keep the value for about 5 seconds, then the corresponding function
will take into effect.
6 Channels (Mode 1):
CHANNEL VALUE FUNCTION
1 0-255
Red
2 0-255
Green
3 0-255
Blue
4 0-255
White
5
000-007
008-015
016-131
132-139
140-181
Strobe
Close
Open
Strobe Slow->Fast
Open
Fast Close Slow Open
11A