27
3
Mehr als nur
T
elefonieren
3
More than only
telephone calls
Call diversion “unconditional”
You want to forward your calls unconditionally to another internal or external tele-
phone. In case of ISDN telephones you can program this also in the menu of the
telephone (--> „manual of the telephone“). Call diversions for door calls see page 39.
Applying for internal telephones:
The telephone you want to divert to, is not allowed to have a call protection.
If the telephone you want to divert to, has also been programmed for call diversion,
your calls nevertheless will be diverted to this telephone.
If you want to divert external calls, the telephone you want to divert to, must have
an external authorization (-->“Configuration”, page 48). If not, you may switch on
call diversion however, but the call nevertheless will not be diverted.
1) Determine destination of the “unconditional” call diversion
An existing “unconditional” diversion will be substituted by the new diversion.
+
#*61
number
Telephone number to be diverted to. In case of
external telephone numbers without 0 for
connection to external line.
#
-
You have now determined the destination of the
call diversion. You must now just switch on the call
diversion.
2) Switch on “unconditional” call diversion
+
#*6011#
-
You have now switched on call diversion. If you lift
the receiver the next time, you hear the special
dialling tone, internal (not with
automatic
connection to external line)
2) Switch off “unconditional” call diversion
+
#*6010#
-
You have now switched off call diversion. The
destination of the call diversion remains stored. If
you want to divert to the same destination later,
you only have to switch on call diversion again.
Clearing destination of “unconditional” call diversion
You want to make sure, that no destination for call diversion is stored any more.
+
#*61#
-
Now no destination for call diversion is stored
any more.
Being obtainable everywhere: call diversions
