15
2
Right around
telephone
conversation
Determine which device type your call shall address
With modern ISDN PABX´s it is possible to assign the internal analogue telephone
numbers to a specific device type. Doing this, mistakes may cause difficulties. For
example, if you try to send a fax to someone. In the case, the line is constantly busy,
it may be, that your partner did not configure the dialled telephone number as fax
connection, but eg as telephone. With input of the socalled service identifier prece-
ding the telephone number, you can discover, if such a mistake is existing. Would
you enter the service identifier for telephone in the present case, the fax could be
transferred.
But also in case everything has been configured correctly, sometimes problems with
the recognition of the device type may occur. For example, if your partner has confi-
gured a fax and a telephone under one
multiple subscriber number of a multiple
subscriber connection. If you program via the service identifier, which device shall
be addressed by your call, nothing will go wrong.
+
#92
eg
1
With this you determine, which device type shall
be addressed by your call.
0
Multi function device (combined fax etc.)
1
Telephone
2
Analogue fax, group 2/3
3
Modem
number
External telephone number of the desired
subscriber. The terminal equipment will
now be called with the programmed service
identifier.
Conversation without Least Cost Routing
You want to inactivate the automatic least cost routing (LCR) for the following con-
versation.
You must have the authorization for that (-->“Configuration”, page 78, exempt
subscriber from LCR ).
+
#96
number
External telephone number, always without 0 for
automatic connection to external line
(eg
01234 56789
).
To call someone
