Installation and Operation Instructions
DLP Series
AUTOMATION COMPONENTS, INC
Version : 5.0
2305 Pleasant View Road
I0000777
Middleton, Wisconsin 53562
Page 1 of 6
www.workaci.com
(888) 967-5224
Figure 1: DLP Dimensions and Hardware
PRECAUTIONS
R
EMOVE POWER BEFORE WIRING
.
N
EVER CONNECT OR DISCONNECT WIRING WITH THE POWER APPLIED
.
D
O NOT ALLOW
LIVE WIRES TO TOUCH THE CIRCUIT BOARD
.
A
N ISOLATION TRANSFORMER IS RECOMMENDED WHEN POWERING THE DEVICE WITH
24
VAC
.
D
O NOT RUN THE WIRING IN ANY CONDUIT WITH LINE VOLTAGE
.
F
AILURE TO WIRE DEVICES WITH THE CORRECT POLARITY WHEN USING A SHARED TRANSFORMER MAY RESULT IN
DAMAGE TO ANY DEVICE POWERED BY THE SHARED TRANSFORMER
.
MEDIA
The DLP can be used to monitor the differential pressure in any application that uses dry air or inert gas.
DIN RAIL MOUNTING (Optional Accessory Ordered)
Attach the DIN Rail Mounting accessory to the back of the enclosure using the two screws provided. To mount the sensor on the DIN
Rail, place the bottom of the DIN Rail Clip into the 35mm DIN Rail and push the unit upward to engage the spring clip. Now press the
top of the unit back until it locks into place
(see Figure 2)
.
Figure 2: DIN Rail Mounting
