Achronix PCIe Accelerator-6D Card, Руководство пользователя

Страница: 17 / 37

PCIe Accelerator-6D Card User Guide (UG074)
Speedster FPGAs www.achronix.com 17
1.
2.
3.
Table 1:
SW3000 Programming Interface Switch Connections
P1 P2 Function
Off On SPI ×1
On Off SPI ×4
Others Disable SPI
Connecting the Board to the Host PC and Running the Application
When programming via the JTAG interface:
Via FTDI – connect the micro-USB cable to the "USB Connector for FTDI" (see figure: PCIe Accelerator-
) port on the board and the other end to the USB port of the host PC. 6D Board Details (see page 9)
– connect the Bitporter pod using the ribbon cable to the "JTAG Header" (see figure: Via Bitporter PCIe
). Connect the USB end of Bitporter pod to USB port of the Accelerator-6D Board Details (see page 9)
host PC.
Power up the board.
Run ACE and switch to "Programming and Debug Perspective" or "HW Demo Perspective" to program the
bitstream.
Once the FPGA is programmed and the CONFIG_DONE LED light is green, the configuration has successfully
completed, and the FPGA has transitioned to user mode. At this point, run any application as desired.
For more details refer to the board and PCIe Accelerator-6D Card Quick Start User Guide Bitstream
. Programming and Debug Interface User Guide