![background image](http://html1.mh-extra.com/html/acer/power-2100/power-2100_user-manual_3952707037.webp)
Index
37
1.7.3
Correcting Error Conditions
As a general rule, the "Press F1 to continue" error message is caused by a configuration problem which can be
easily corrected. An equipment malfunction is more likely to cause a fatal error, i.e., an error that causes a
complete system failure.
Here are some corrective measures for error conditions:
1.
Run Setup (see Chapter 3). You must know the correct configuration values for your system before you enter
Setup, which is why you should write these values down when the system is correctly configured. An incorrect
Setup configuration is a major cause of power-on error messages, especially for a new system.
2.
Remove the system cover according to the directions in Chapter 4, Installing Optional Components. Verify
that the system board and any expansion boards are configured correctly.
3.
Check that all connectors and boards are secure. Refer to Chapter 4 (Installing Optional Components) for
assistance.
If you have purchased a new hard disk drive
and cannot access it, it may be because
your disk is not physically formatted.
If you have followed the suggested corrective steps above and still receive an error message, the cause may be an
equipment malfunction.
If you are sure that your configuration values are correct and your battery is in good condition, the problem may lie
in a damaged or defective chip. Contact an authorized service center for assistance.