English 8
Operation
Turn On/Off Procedure
A
Power on
Press the Standby/On key to turn on the lamp. The LED will blink green during warm up and then light
solid green.
¾
"INPUT SIGNAL DETECTED, ACTIVATING AUTO IMAGE" will be displayed on the screen after the
projector has identified the input signal;
¾
“SEARCHING“ message will be displayed on the screen if there is no signal input;
¾
“SYNC IS OUT OF RANGE” message will be displayed on the screen if the horizontal frequency of the
input signal exceeds the range of the projector.
B
Standby
Press the Standby/On key for more than one second to turn off the lamp. The LED will then blink
orange and the lamp will shut down, but the fan will continue to run for about
1 minute to cool the
lamp. After the fan stops, the LED will turn to a light solid orange.
*Lamp Protection Procedure: If you try to turn on the lamp again while the LED is blinking, the projector will ignore
the command until it has cooled down for one minutes.
External Control
A
Control Pad
Figure 12 External control pad
3
Downloaded From projector-manual.com BenQ Manuals
