37
Eng
lis
h
Problems with the Projector
9
Image is too small
or too large
•
Adjust the zoom lever on the top of the projector.
•
Move the projector closer to or further from the
screen.
•
Press "MENU" on the control panel or remote
control. Go to "Image" > "Aspect
Ratio" and try
different settings.
10
Image has slanted
sides
•
If possible, reposition the projector so that it is
centered on the screen and below the bottom of the
screen.
•
Press the Keystone correction keys on the control
panel or remote control until the image becomes
square.
•
Press "MENU" on the control panel or remote
control to open the OSD menu. Go to "Image" > "H/
V Keystone" or "Image" > "4 Corner Correction" to
make adjustments.
11
Image is reversed
•
Select "Image" > "Projection Mode", "Image" >
"Projection Location" on the OSD and adjust the
projection direction.
#
Condition
Solution
1
The projector stops responding
to all controls
•
If possible, turn off the projector, then
unplug the power cord and wait at
least 30 seconds before reconnecting
power.
•
Make sure that the control panel lock
function is disabled.
2
Lamp burns out or makes a
popping sound
When the lamp reaches the end of its useful
life, it will burn out and may make a loud
popping sound. If this happens, the projector
will not turn on until the lamp module has
been replaced. To replace the lamp, contact
your local dealer or Acer service center.
