![background image](http://html1.mh-extra.com/html/acer/aspire-x1930/aspire-x1930_service-manual_4161766069.webp)
Aspire AX1930 Service Guide
61
Configuring the ME Firmware
You need to disable the Manageability Engine (ME) firmware before updating the BIOS. Use the
ME_DISABLE jumper to do this.
•
1-2 position: Normal operation (default)
•
2-3 position: ME disable
To disable the ME firmware:
1.
Turn off the power to the computer and all peripherals.
2.
Unplug the power cord from the computer.
3.
Unplug the network cable and all connected peripheral devices from the computer.
4.
Place the computer on a flat, steady surface with the rear cover facing upward.
5.
Remove the computer cover by following the procedures described on page 22.
6.
Remove the graphics card by following the procedure described on page 34.
7.
If necessary, remove any other assemblies or cables that prevent access to the ME_DISABLE jumper.
8.
Locate the ME_DISABLE jumper on the mainboard.
9.
Remove the jumper block and set it over the 2-3 pins for 20 to 30 seconds.
10.
Return the jumper block to its default 1-2 position.
11.
Reinstall the graphics card.
12.
Reinstall any any other assemblies or cables that have previously been removed.
13.
Reinstall the computer cover.
14.
Connect the power cord to the system.
15.
Press the power button to turn on the computer.
16.
During POST, press
Delete
to access the Setup Utility.
17.
Press
F9
to load the system default values.
18.
Press
F10
to save the changes you made and close the Setup Utility.
Содержание Aspire X1930
