Acer Altos 12000 Series, Руководство пользователя

Страница: 89 / 172

Index
lxxxix
3.9.3 Correcting Error Conditions
As a general rule, if an error message says "Press F1 to continue," it is caused by a
configuration problem, which can be easily corrected. An equipment malfunction
is more likely to cause a fatal error, i.e., an error that causes complete system
failure.
Here are some corrective measures for error conditions:
•
Run Setup (see section 4.1). You must know the correct configuration
values for your system before you enter Setup, which is why you should
write them down when the system is correctly configured. An incorrect
configuration is a major cause of power-on error messages, especially for a
new system.
•
Remove the system unit cover (see section 2.2). Check that the jumpers on
the system board and any expansion boards are set correctly.
•
Check that all connectors and boards are securely plugged in.
•
If you cannot access a new disk, it may be because your disk is not properly
formatted.
If you go through the corrective steps above and still receive an error message,
the cause may be an equipment malfunction.
If you are sure that your configuration values are correct and your battery is in
good condition, the problem may lie in a damaged or defective chip.
In either case, contact an authorized service center for assistance.