![background image](http://html.mh-extra.com/html/acer/acerpower-f6/acerpower-f6_service-manual_5753044.webp)
36
Chapter 2
PCI/PnP Configuration
This page sets up some parameters for devices installed on the PCI bus and those utilizing the
system plug and play capability.
Allocate IRQ to PCI VGA (Yes)
If this item is enabled, an IRQ will be assigned to the PCI VGA graphics system. You set this value
to No to free up an IRQ.
IDE Bus Master (Enabled)
This item is used to enable or disable IDE Bus Master.
Help Item
Allocate IRQ to PCI VGA
Yes
IDE BusMaster
Enabled
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
PCI / PnP Configuration
YES: Assigns IRQ to
PCI VGA card if card
requests IRQ.
NO: Does not assign
IRQ to PCI VGA card
even if card requests
an IRQ.
F10: Save & Exit
+/-/: Value
Enter : Select
ESC: Exit
F9: Optimized Defaults
F1:General Help
: Move
Содержание AcerPower F6
