Ace ACE-3205, Инструкция по установке и эксплуатации

Страница: 363 / 418

Installation and Operation Manual Appendix C ATM OAM Functionality
ACE-3105, ACE-3205 Ver. 5.2 OAM Modes of Operation over ATM C-3
ƒ
When a failure is detected on the physical port, AIS state is declared and
F4 end-to-end AIS cells are generated towards the forward direction.
Figure C-4. VP Intermediate Point – Case D
• For OAM loopback cells (see C.3 OAM Loopback ), an ID match check
determines the loopback state:
Figure C-5. VP Intermediate Point – Case E
VC Intermediate Point
When a VC connection point is set as an intermediate point, it operates as
follows:
•
If the other side of the VC XC is also set as an intermediate point:
ƒ F5 segment and end-to-end OAM cells are forwarded transparently to the
other side of the XC. F4 segment and end-to-end OAM cells are dropped
from the cell stream.
Figure C-6. VC Intermediate Point – Case A
ƒ When a failure is detected on the physical port, AIS state is declared and
F5 segment AIS together with end-to-end AIS cells are generated towards
the forward direction.