Ace ACE-3105, Инструкция по установке и эксплуатации

Страница: 245 / 418

Installation and Operation Manual Chapter 6 Monitoring and Diagnostics
ACE-3105, ACE-3205 Ver. 5.2 Monitoring Performance 6-7
Parameter Description Possible Values
• Holdover – An idle timing mode in which
the internal clock chip reinstates the
timing of the previously active
master/fallback clock source.
For more information about these clock
states, refer to
Appendix D
.
Recovered ID ID of the recovered clock stream 1
³
To view the recovered clock statistics:
• From the Recovered Clock menu, select Statistics.
The recovered clock statistics are displayed.
ACE-3205 – RAD Data Communications
Monitoring> System> Clock> Recovered clock> Statistics
RX packets ... (93814)
Lost packets ... (0)
Out of order packets ... (0)
Buffer underflow ... (0)
Time elapsed ... (100)
Valid intervals ... (1)
1. Interval ... (0)
2. Recovered ID ... (1)
PW number ... (1)
>
Please select item <1 to 2>
ESC-previous menu; !-main menu; &-exit
Figure 6-9. Recovered Clock Statistics
Table 6-6. Recovered Clock Statistics Parameters
Parameter Description Possible Values
RX packets Number of good clock packets that have
been received Numerical
Lost packets Number of lost clock packets Numerical
Out of order
packets Number of detected out-of-order packets Numerical
Buffer underflow Number of underflow events that have
occurred in the clock stream buffer Numerical
Time elapsed /
Start time Elapsed time (in seconds) since the
beginning of the current interval.
Start time is for intervals 1–24.
0–899