WEARING YOUR PEDOMETER
While gently holding the belt clip open, slide the pedometer
onto your belt or the top edge of your pants or skirt. It should
fit snugly and level, above one knee.
Note:
The pedometer should be as vertical as possible. Walkers
with larger stomachs may find it helpful to wear the pedometer
farther back on the body, toward one hip.
The cover must be closed for the pedometer to work.
To avoid
losing or dropping your pedometer, use the included leash and
clip to fasten the pedometer securely to your clothing.
Attaching the Leash:
Attach the pedometer to the leash by
looping the leash around the pedometer belt clip. Next, clasp the
waistband of your clothing with the attached metal clip. You can
also use a safety pin to fasten the leash to your clothing, loop
the leash through your belt or belt loop, or use a badge holder.
VIEWING YOUR RESULTS
Once you put on your pedometer with the cover closed, it will
automatically begin to record your steps. Repeatedly press the
aqua MODE button to cycle through the pedometer modes:
DAILY STEPS
→
TOTAL STEPS
→
PACE
→
GOAL%
→
ACTIVITY
TIMER
→
DAILY STEPS
MEMORY PEDOMETER
OPERATING INSTRUCTIONS
ACCUSPLIT, Inc. • 6120 Stoneridge Mall Rd., Suite 210 • Pleasanton, CA 94588 USA
800-965-2008 • 925-226-0888 • FAX 925-463-0147 • www.ACCUSPLIT.com • [email protected]
ACCUSPLIT®
EAGLE
™
1622M4
Eat Right! Walk More! Live Well!
The ACCUSPLIT Lifestyle
Congratulations on taking the first step to wellness
with your purchase of an ACCUSPLIT pedometer.
It’s easy to set up your new pedometer.
Just follow the steps below, and start walking!
970-067
First, loop the
pedometer clip
Next, loop the metal clip,
then clasp clothing
Or, loop a
badge holder, then
put into pocket
(Badge holder not included)
Or, loop a belt or
belt loop
NO-PROOF-OF-PURCHASE LIMITED WARRANTY
See label inside the lid of the pedometer.
AUTO MOVEMENT SENSOR
1. To filter out random movements, the unit remains in standby mode until
5 continuous steps are registered. Only then are the 5 steps calculated in,
and an Active indicator “
▲
” appears on the upper left of display.
2. When regular walk/run movement stops, after 2 seconds the timer pauses
and the unit switches to standby status (Active indicator “
▲
” disappears)
RESETTING YOUR PEDOMETER
Most people prefer to reset step counts daily. To reset: While displaying Day’s
STEPs, press and hold yellow RESET button for at least two seconds to reset
to zero. When displaying Total STEPs, press yellow RESET button for two
seconds to reset Total and Day’s STEPs to zero.
GOAL SETTING
Your unit is set to a goal of 10,000 steps per day, as recommended by walking
experts. To change the step goal, press the aqua MODE button repeatedly until
you are in GOAL % mode. ACCUSPLIT products follow a standard setting
procedure known as SET1-2-3-4. Press and hold the cream SET button for
2 seconds to enter setting mode (SET 1/2). Display will show your daily step
goal (in steps). Press the cream SET button to increase your daily step goal
(SET 3+), in 500 step units. Press the yellow RESET button to decrease your
daily step goal (SET 3–). Press the aqua MODE button to exit setting mode
(SET 4), or simply wait a few seconds and unit will exit setting mode
automatically.
REPLACING THE BATTERY
When the display starts to dim or goes blank, it is time to replace the battery.
Your pedometer uses one Type LR43 (L1142) 1.5 volt alkaline battery. To
replace:
1. Insert a coin into the slot on the bottom of the case, and twist counter-
clockwise to loosen the case front. Lift case front away.
2. Using a pen or other thin object, push battery sideways out of its holder.
Replace it with a new battery. The battery’s positive (+) terminal should
be FACE UP while you put it into the pedometer.
3. Align case front over the pedometer and press gently to
snap cover back into place, starting with top.
ACCUSPLIT
EAGLE
1622M4
50
80
100%
20
0
GOAL%
TW15MG
STEP
DAY TOTAL PACE GOAL%
MODE
SET4
RESET
TARGET
MY
GOAL
™
SET1/2
SET 3
+
–
425 I
Aqua:
MODE
Cream:
SET
Yellow:
RESET
REGISTER NOW
Please return
your AE1622M4 Registration to
the Repair Center address in the
warranty, and we will let you
know about future products.
Email (preferred)
User
DISPLAY MODES
• DAY (Day’s STEPS): Counts steps taken since last RESET.
Reset daily to count each day’s steps.
• TOTAL (Total STEPS): Keeps track of all steps taken, even after
Day’s STEP
S
are reset.
• PACE: Mode shows rate of stepping in steps/minutes.
• GOAL%: Visually shows your progress towards today’s stepping goal.
•
(ACTIVITY TIMER): Shows total activity time in minutes and
seconds since last reset. The timer runs automatically whenever
steps are being recorded.
