www.accuenergy.com
49
V: 1.0 Revised: Sept. 2019
Chapter 10: Web Interface Readings and Parameter Settings
Communication
The basic metering configurations needed to set up the meter can be applied from the web
interface by clicking on Settings and selecting the 'Meter' tab.
The communication setting web page will allow the user to configure settings related to the
Ethernet network. The functions that the L-WEB support can be configured from this web page
by selecting the corresponding tab such as Emails, Time/Date , Datalog, HTTP/FTP Post, Acu-
Cloud Post for communicating with the AcuCloud software, SNMP, BACnet and DNP3.
Network:
DHCP: Select 'Manual' to manually configure the IP address to access the meter. If set to 'Man-
ual', you'll also need to set the Subnet Mask and Gateway.
Select 'Auto' to have the meter assigned a IP address automatically. With this selection the
Subnet Mask, Gateway and DNS servers will also be automatically assigned.
NOTE: After changing DHCP to Auto, check the display of the meter to obtain the new IP
address that has been assigned after the L-WEB has completed its reboot and the router has
assigned the meter with an IP address.
IP Address: If the DHCP is configured to Manual, the IP address can be configured from this
page.
Subnet Mask: If the DHCP is configured to Manual, the Subnet Mask can be configured from
this page.
Gateway: If the DHCP is configured to Manual, the Gateway can be configured from this web
page.
DHCP DNS Server 1: Enter the address of the DNS 1 server in this page.
DHCP DNS Server 2: Enter the address of the DNS 2 server in this page.
Allow HTTP: Enable this setting so that the L-WEB can be accessed through HTTP at port 80.
HTTPS Port: Enter the HTTPS port number of the meter. By default, this setting is configured to
443. The range can be from 6000 to 9999.
