Unwrapping new rolls and tightening loose rolls
After loading the wrapped roll, cut the plastic the full length of the roll and at each end. Position the load
cradle
roller directional switch
in the reverse position, and then step on the
foot cable control
while
pulling off the plastic wrapping.
If you have a loose roll, run the
load
cradle
rollers in reverse by placing the load cradle
roller directional
switch
in the reverse position and pressing the
jog button
or stepping on the
foot cable control
to acti-
vate the load cradle rollers. Continue to run the rollers in reverse until the roll has tightened.
Positioning the material
Raise the
hold down arm
, lifting it off the
measuring wheel
. Set both
roller directional switches
to for-
ward. Step on the
foot cable control
or press the
jog button
, advancing the material to the center of the
cutting track
(see photo 3A).
Now lower the
hold down arm
back on to the
measuring wheel
.
Failure
to lower the
hold down arm
will result in an inaccurate measurement.
Note
:
If the material is off square, line the trailing edge of the material with the
cutting track
(see photo 3B).
Photo 3A
Photo 3B
