Acclaim Lighting Flex One Exterior HO, Руководство пользователя

Страница: 12 / 30

10
www.acclaimlighting.com
+24
V
+24
V
+24
+24
V
+24
V
TO SURFACE MOUNT USING BRACKETS
1 If necessary, carefully solder to the contact pads
(see page 5).
2 Fit the Flex One tape to the channel (see page
9).
3 Attach two or more brackets (of the required
type:
Flat brackets
or
Angled brackets
) to the
mounting surface using either the supplied
screws or others that are more appropriate to
the surface type.
The angled bracket can be used in either of
two orientations to provide an angle of either
30 or 45 degrees to the mounting surface (as
shown below).
4 Clip the channel into the mounting brackets:
If necessary, solder
the link cables to
the contact pads
Attaching a flat
bracket
Attaching an
angled bracket
45 degrees 30 degrees
The angled bracket can be used in either of two orientations to
provide angles of either 30 or 45 degrees to the mounting surface
TO SURFACE MOUNT DIRECTLY
1 Before fitting the Flex One tape, determine
where the channel is to be mounted.
2 Drill the required number of holes in the base of
the channel and countersink them. Note: A small
groove runs down the center of each channel base
to provide a guide for your drill.
3 Mount the channel and use countersunk screws
to secure it.
IMPORTANT: The screw heads must
lie flush with the channel base.
4 Fit the Flex One tape to the channel (see page 9).
5 Carefully solder to the contact pads, if necessary
(see page 5).
Drill countersunk holes and
use screws that will
lie flush with the
channel base
Using a flat bracket to
join two channels
Note: Ensure sufficient
strain relief where the
cables enter the channel.