Access Laser L15 Series, Руководство оператора

Страница: 11 / 29

L15 Series Operator Manual 11
Laser Operation Instructions
Operating the Laser
1. Close the laser shutter (if present).
2. Direct the laser toward an appropriate target, such as a power meter or a beam-
blocking device. (See Safety Information regarding appropriate beam blocking
devices.)
3. Secure the laser to a bench top using the mounting holes in the laser body.
Do not torque, twist or bend the laser body during the mounting process. Applying
uneven pressure to the laser body may distort the laser body, causing poor
performance and possible damage.
4. Connect the Cooling System
a. Air Cooled Lasers (where cooling is provided by the end user)
i. If no cooling is built in to your laser, you are responsible for providing
sufficient cooling to maintain the laser specifications. (See Air Cooling
Section for specifications.)
ii. Connect your air cooling system to the laser.
b. Built-in Fan Cooled Lasers
i. Connect the 12V DC supply to the fan power connector.
5. Connect the RF cable to the BNC connector on the laser.
6. Connect the RF cable to the TNC connector on the RF Driver.
7. Connect your 5V TTL source to the TTL gate (BNC connector) on the RF Driver.
8. Set the TTL input to 0V (0V = OFF; 5V = ON).
9. Connect the RF Driver to the appropriate DC power supply.
a. L15: 36V DC
b. L15P: 48V DC
c. L15D: 36V DC for Continuous Wave operation. 48V DC for Super Pulse
operation.
NOTE: Red wire is positive. Black wire is negative.