background image

Universal Voltage 26W, 38W, 52W permits operation at 

120VAC thru 277VAC or 347VAC or 480VAC, 50 or 60 Hz.

Add: 

1501 Industrial Way N, Toms River, NJ 08755   

Phone:

 866-222-8866   

E-mail: 

[email protected]

 

Web:

 www.AboveAllLighting.com ©2016 ABOVE ALL Lighting, Inc. All rights reserved

1

LED V-LINE FLOOD LIGHT

Instructions Manual

SUITABLE FOR MODEL

WIRE CONNECTION

Make the following Electrical Connection:

a). Connect the voltage supply line to ACL in Black.

b). Connect the voltage supply Neutral to ACN in White.

c). Connect Green ground lead to the supply ground lead.

SAFETY INSTRUCTION

READ CAREFULLY BEFORE INSTALLING FIXTURE. 

PLEASE KEEP THIS MANUAL FOR FUTURE USE.

Fixtures must be wired in accordance with the National 

Electrical Code and all applicable local codes. Proper 

grounding is required for safety.

THIS PRODUCT MUST BE INSTALLED IN 

ACCORDANCE WITH THE APPLICATION CODE BY 

A PERSON FAMILIAR WITH THE CONSTRUCTION 

AND OPERATION OF THE PRODUCT AND THE 

HAZARDS INVOLVED.

MAKE CERTAIN POWER IS OFF BEFORE 

INSTALLING OR MAINTAINING FIXTURE.

CHECK THAT VOLTAGE IS COMPATIBLE WITH 

FIXTURE DRIVER. USE APPROVED CONNECTORS 

FOR ALL ELECTRICAL CONNECTIONS.

MAINTENANCE CAUTION

1. Review the wire connection before beginning, and 

make sure fixture is grounded properly.

2. For lighting controls, follow control instructions 

carefully.

3.  Turn  power  off  and  wait  for  fixture  to  cool  before 

performing maintenance.

4. Maintenance must be done by professionals.

Note:

 If fxture is furnished with photocell receptacle, 

please make sure install the photocell or shorting cap

INSTALLATION

ACCESSORY PACK

WIRE NUT X 5

1.  Turn off the power.

2.  Locate the mounting points based on the Dimension 

Drawing. See Figure 1.

3.  Install the trunnion to a desired bracket try by (2) 

Bolts,  (2) Locking Washers  and  (2) Nuts (all not 

supplied) .

4. 

Adjust the angle of the fixture by trunnion.

      a. Loosen the (2) center bolts and (2) angle locking

          screws on the trunnion.

      b. Swivel fixture to a desired angle.

      c. Tighten (2) center bolts and (2) angle Locking

          Screws.    

5.  Make the necessary wire connections and waterproof. 

Connect wires  as above wiring diagram.

TRUNNION MOUNT (TR)

All manuals and user guides at all-guides.com

Отзывы: