3. Building and running project
AT3108U Demo board quick start guide
22
3.5.3
How to enter Sleep Mode
1.
When entering Sleep Mode from Fast Mode (Active Mode), make sure to disable Fast Mode
first and then, enable Sleep Mode.
A.
Fast Mode Disable: CTRL1 &= (~0x80);
B.
Sleep Mode Enable: CTRL2 = 0x04;
2.
When entering Sleep Mode from Fast Mode, the required Delay Time can be adjusted by
configuring the STOP_DELAY register (Default value is 2sec). If a Touch Event is generated
in Sleep Mode, Fast Mode is maintained for the time set in the STOP_DELAY register.
3.
Idle Duty time in Sleep Mode can be adjusted by configuring the PMOD register (Default value
is 300ms).
4.
To the STOP_WAKECL and STOP_WAKEL registers, a basic setting rule is applied. A level
of the STOP_WAKEL register (100%) must be set always higher than the setting level of the
STOP_WAKECL register (50%).
Figure 22. Timing Diagram of Delay Time in Sleep Mode (Snap Mode)
Содержание AT3108U
Страница 27: ...AT3108U Demo board quick start guide 3 Building and running project 27 Figure 26 AT3108 h continued ...
Страница 28: ...3 Building and running project AT3108U Demo board quick start guide 28 AT3108 c Figure 27 AT3108 c ...
Страница 29: ...AT3108U Demo board quick start guide 3 Building and running project 29 Figure 27 AT3108 c continued ...