3. Building and running project (Shield board)
A31G324RLN shield board implementation guide
26
3.5.3
Downloading Buzzer
If the compilation finishes without any error, you can begin programming the Starter Kit.
1.
Check the followings if errors occur during the setup process.
A.
Check that CMSIS-DAP Debugger (
①
) is selected in the Debug tab (use CMSIS-DAP for
A-Link).
B.
Click Settings and check that A-Link CMSIS-DAP (
②
) is selected in the Debug tab.
C.
Check that the correct flash loaders of the device (
③
) are displayed in the Flash Download
tab.
Figure 29. Check to Buzzer Project Setting
2.
Downloading is enabled since the Starter Kit is connected to the USB port of the PC.
3.
Click Download (
①
) to download. Check the settings if you encounter errors.
Figure 30. Download Buzzer Project on A-Link
①
②
③
①
Download