ABL WALLBOX eMH2 EN, Инструкция по установке и эксплуатации

Страница: 11 / 36

Installation –
Preparing and fixing the wallbox in place |
11
6
Insert two of the included panhead screws into
the two upper fixing points using the screwdriver
(Torx) or the electric drill and Torx bit.
y
The distance between screw head and wall
must measure 4 mm.
4 mm
Preparing and fixing the wallbox in place
Continue to prepare the wallbox:
7
Open the housing cover of the wallbox with the
housing cover key and put it aside.
8
Loosen the screw of the internal electronic com-
ponents cover using the screwdriver (Torx) and put
it aside.
y
Keep the screw in a safe place.
9
Use the utility knife to cut an opening for the
power supply cable into the large rubber grommet
in the housing base.
y
For wiring up group installations, you must also
make cuts into the two smaller grommets for
the data cables (see "Data cable connections"
on page 14).