ABL eMC2, Руководство пользователя, Страница: 7 / 44

IMpORTANT INfORMATION
3
• Do not install this device in close vicinity to running water or water jets. However,
the
eMC2
is sufficiently protected against water splashes and sprays according to
IP44.
• The eMC2 charging pole must not be installed in explosive atmosphere areas (EX
areas).
• The eMC2 charging pole must not be installed in areas subject to flooding.
• Please note that the
eMC2
charging pole must under no circumstances be in-
stalled directly on blacktop: For safe and proper installation, a concrete foundation
must be planned for with specifications according to the requirements listed on
page 33.
• The charging pole must also be installed on a suitable plinth: The plinth can be ob-
tained from
ABL
as an optional accessory (see also page “Available accessories”
on page 11).
• Please note that additional overvoltage protection may be required depending on
the vehicle to be connected or national regulations.
• Please not that some countries and/or different vehicle manufacturers may require
a different tripping characteristic for the residual current circuit breaker (Type B). In
this case, please contact your distributor.
Operating instructions / Maintenance
Please note the following instructions for the operation and maintenance of your
charging pole:
• The device must at all times be connected to the protective earth conductor of
your power supply.
• Ensure that the rated voltage and rated current of the device comply with the
parameters of your local electricity grid and that the rated output is not exceeded
during charging operations.
• Comply at all times with local safety regulations for the country in which you oper-
ate the charging pole.
• To disconnect the charging pole completely from the power grid, the power supply
must be cut at the upstream domestic miniature circuit breakers (MCB).
• Never install or operate the charging pole in confined spaces. It must be ensured
in particular that, for charging, vehicles can be positioned at the required distance
from the charging pole and connected without any strain on the charging cable.
• Make sure that the door at the front of the charging pole is always locked to pre-
vent unauthorized opening of the housing. Keep the door key in a place that is only
known to authorized users.