Resetting the wallbox and restoring to factory settings |
57
4
Place the axle of the new door on the wallbox’s hinge
alignment and pull first one and then the other side
forward with moderate force.
• The axle will snap into the wallbox’s hinge
alignment.
5
Check that the new housing cover moves freely and
fold it upwards so that it locks into the housing.
6
Fold down the two side RCCB flaps and lock them
with the key.
This completes the replacement of the housing cover.
Resetting the wallbox and restoring to factory settings
If an error occurs during operation or configuration, you can reset the Wallbox eM4 Twin without changing the cur-
rent configuration parameters. Alternatively, you can reset the wallbox to its factory settings to set up a completely
new configuration or to initialise a configured wallbox for sale.
Reset via the MCB in the domestic power distribution
For a simple reset, switch off the power to the wallbox for about 30 seconds via the MCB connected upstream in the
domestic power distribution. After you have restored the power supply, the wallbox will restart without making any
changes to the configuration parameters.
Resetting the wallbox via the ABL Configuration App
The
ABL Configuration App
provides access to its integrated help system via the button. This button is dis-
played at the top right of the screen for selecting the operating mode. If you tap the button during onboarding or in
the Control Board, you can restart a Controller wallbox via the
Reset to factory settings
option. After restarting, all
configuration parameters are reset to the factory default.
NOTE
Accessing the help system on an Extender wallbox
If you tap the button while the
ABL Configuration App
is connected to an Extender wallbox, you will be redi-
rected directly to ABL’s support website.
Resetting or restoring the wallbox via the reset pushbutton
There is a reset pushbutton on the main module of the wallbox which you can use to restart the hardware or reset the
wallbox to its factory settings, depending on how long you press the button.