Control Board settings and reboarding |
45
Description of the charging process
After setting up via the
ABL Configuration App
, the setup is complete and the Wallbox eM4 Twin is ready for
charging. We recommend carrying out an initial charging process with a vehicle during start-up to ensure the func-
tionality of the wallbox.
The charging procedure is described below using the right-hand charge point as an example. For the left-hand charge
point, the steps are identical, but the status indicator is mirrored.
Proceed as follows:
1
Park your electric vehicle so that its charging inlet can be easily reached with the charging cable's charging
connector.
2
Check the status indicator of the charge point.
Display: 1 cycle)
• When the charge point is ready for charging, the
status indicator pulsates green.
3
Prepare the charging cable of the wallbox and the
vehicle's charging inlet.
• Open the charging inlet at the vehicle and plug in
the charging connector.
• Open the charging socket lid on the wallbox and
plug in the charging connector.
4
Check the status indicator of the charge point.
• When the vehicle is connected and recognised,
the status indicator lights up static green.
NOTE
Authorisation of the charging process with the Wallbox eM4 Twin
Depending on the model version, the Wallbox eM4 Twin can be configured differently during installation.
Controller:
A Controller can be operated as a stand-alone wallbox or with a backend.
Controller with Extender:
A Controller can be operated with one or more Extender wallboxes as a group in a
backend or without a backend.
Stand-alone Extender:
An Extender configured for stand-alone operation is operated without a backend.
If it is necessary to authorise the charging operation via an RFID card, carry out the following steps
5
to
7
. If au-
thorisation is not required, go to step
8
.