EN - 10
8 Maintenance and cleaning
MAG Welding torches
8.1 Cable assembly
1
Unscrew the cable assembly on the machine side and bring it into a
stretched position.
2
Unscrew retaining sleeve and pull out liner and replace it, if necessary.
3
Remove worn parts from the torch neck.
4
Clean wire conduit from both sides with compressed air.
5
Slide adjusted liner into wire conduit and secure with retaining sleeve.
6
Connect cable assembly on the machine side with wire feed unit.
8.2 Torch neck
1
Remove gas nozzle.
2
Remove welding spatter and spray gas nozzle using the
ABICOR BINZEL
anti-spatter agent.
3
Check wearing parts for visible damage and replace them, if required.
WARNING
Risk of injury
Serious injuries caused by parts swirling around.
• When cleaning the wire guide liner with compressed air, wear suitable
protective clothing, in particular safety goggles.
