Abicor Binzel PP Series, Руководство по эксплуатации

Страница: 27 / 68

EN - 11
PP 4 Putting into operation
4.4 Setting the shielding gas quantity
4.5 Feeding in the wire
1 Insert the wire in the wire feeder as specified by the manufacturer.
2 Remove clamping cap (2) from handle (6) .
3 Swing out seat clamp (7) laterally.
4 Press the "Current-less wire feed" trigger at the wire feed unit until the wire
emerges from the contact tip.
5 Lock seat clamp (7) and attach clamping cap (2) .
NOTE
• The type and quantity of the shielding gas depends on the welding task
and the gas nozzle geometry.
• Make all shielding gas connections gas-tight.
• To prevent the shielding gas supply from becoming clogged by
impurities, the cylinder valve must be opened briefly before connecting
the cylinder. This will expel any impurities that may be present.
1 Torch neck
2 Clamping cap
3 Flat-head screw
4 Fixing plate
5 Potentiometer (optional)
6 Handle
7 Seat clamp
Fig. 6 Feeding in the wire
1 2
7 5 6
4
3
NOTE
• Each time the wire is changed, make sure that the beginning of the wire is
free of burrs.
• Make sure that the wire feed roll complies with the diameter of the
inserted wire electrode.

8.1 Replacing the wire feed roll on page EN-14