Abicor Binzel MFS-V3 M-Drive, Руководство по эксплуатации, Страница: 77 / 124

MFS service software 8 User levels/user rights
EN - 15
8 User levels/user rights
Further information about the options offered by the individual user levels plus more detailed explanations
of these can be found in the ‘User levels and rights’ section of this manual.

15 Releasing the user levels and rights on page EN-58
NOTICE
• The software has three user levels.
Description Screenshot
User level 0 is freely
accessible to all users.
User level 1 is password
protected.
User level 2 is password
protected and is used for
configuration purposes by
qualified personnel.
User level 0 The software always starts in level 0 mode. At this level, it is only possible to start existing visualisation
configurations or open existing log files. The Settings menu is hidden and it is not possible to create, load,
change or save setups.
User level 1 A password is required to access level 1. The initial password is ‘BiVisu’ and can be changed at any time.
The default password for level 1 can be reset by entering ‘RESETPW’ in the level 2 field. In level 1 mode,
setup files can be loaded but not modified or saved.
User level 2 In level 2 mode, all settings and parameters can be configured without any restrictions. This level is only
intended for use by qualified personnel.
The password for this level is ‘MASTER’ and should only be given to qualified or trained specialists.