Abicor Binzel MFS-V3 M-Drive, Руководство по эксплуатации, Страница: 66 / 124

EN - 4
4 Connecting the eBOX to a PC MFS service software
4 Connecting the eBOX to a PC
There are three ways of establishing a connection between the eBOX and a PC:
1 USB/RS converter (881.3220.1) required (eBOX MFS-V2 only)
• Switch off the eBOX and disconnect it from the mains.
• Connect the RS interface converter to the SERVICE connection bush on the eBOX.
• Connect the converter to the PC via a USB port.
• Connect the eBOX to the mains power supply.
• Switch on the eBOX.
2 Connection via Ethernet (eBOX MFS-V3 and eBOX MFS-V2 with Profinet only)
• Switch on the eBOX.
• Establish a connection between the eBOX and PC using an Ethernet patch cable.
• Connect to the mains.
3 Connection via CAN (eBOX MFS-V3 with hand terminal MF control only)
• Connect the MF control to the eBOX (X10 hand terminal).
• Switch on the eBOX.
The MF control comes with Windows 7 Embedded and boots as soon as the eBOX is switched on.
Software Microsoft Excel (for importing CSV files)
Connection At least one free USB interface or Ethernet port
eBOX MFS-V2 Firmware version 6.5 or above
eBOX MFS-V3 Firmware version 5.0 or above
NOTICE
• The following steps must only be completed by qualified personnel (in Germany, see
TRBS 1203).
• Observe the safety regulations in the operating instructions for the individual components.
• Note that, with older MFS V2 eBOXes, there is a risk of identifying the service interface incorrectly on
the hand-held unit.
• eBOXes with a serial number < E0051 are not suitable for this software and may damage the
hardware (USB converter).
NOTICE
• To prevent data losses, always properly shut down the MF control operating system before
disconnecting the X10 plug or switching off the eBOX.