Abicor Binzel MFS-V3 M-Drive, Руководство по эксплуатации, Страница: 118 / 124

EN - 56
14 Warnings and error messages (status) MFS service software
Description Screenshot
Presentation of the messages
All warnings and error messages are only logged and displayed in the case of active communication and an active ‘Job Window’ or
‘Monitoring Window’.
The visual indication is provided by means of a banner located above the ‘Job Window’ or ‘Monitoring Window’.
- Warnings are indicated in yellow. - Error messages are indicated in red.
Message list
Depending on the system configuration, the following warnings and error messages can occur.
There is no nonconformity and the system is
ready for operation.
The eBOX reports that the selected job does
not exist. A job is classed as valid as soon
as it has been stored on the eBOX
regardless of the parameter values. As soon
as a job memory location is deleted on the
eBOX, the memory location is classed as
invalid.
The key switch on the eBOX was switched
from ‘Auto’ to ‘Service’ during the active
process.
The process was started despite the key
switch on the eBOX being set to ‘Service’.
The M-Drive’s protection cover is not closed
on systems with an M-Drive.
The motor output stage for the master drive
is reporting an error due to an excess
current or the overheating of the motor
output stage.
The motor output stage for the slave drive is
reporting an error due to an excess current
or the overheating of the motor output
stage.
The fact that the control lead for the drive is
not properly connected to the eBOX is
reported on systems without an M-Drive.
The process was started without a defined
system mode (see bit pattern for the
operating mode).
The wire actual value is outside the
specified permissible deviation in
window 1.
The wire actual value is outside the
specified permissible deviation in
window 2.
The rear drive’s motor current exceeds the
value specified for the pre-warning in the
job.
The rear drive’s motor current exceeds the
value specified for the error in the job. The
system switches off with an error message.
The front drive’s motor current exceeds the
value specified for the pre-warning in the
job.