Abicor Binzel MFS-V2, Руководство по эксплуатации

Страница: 44 / 132

EN - 22
14 Options MFS-V2
APD main menu:
Drives stop! This trigger is used to stop the drives.
APD main menu:
Wire feed forward Press this trigger to activate the Wire feed mode. This mode is used to feed in the
welding wire again into the cable assembly, for example following a wire fault, a
wire spool change or for setup. In the Wire feed mode, the speed is increased in
a ramp from 0.5 to 8.0 m/min. This value is pre-set and is not affected by the set
setpoint.
APD main menu:
Wire feed backward This trigger is used to run the drives in Creep mode backwards. This serves, for
example, for positioning the end of wire precisely above the work-piece. To prevent
the welding wire from getting entangled, the duration of the reverse mode is
limited.
APD main menu:
Reset This key is used to reset the control after an error.
APD main menu:
Gas valve on!
DG= 0.0 m/min This trigger is used to switch the gas valve (M-Drive) on or off.
APD main menu:
Select function
Current temp=23°C Press this trigger to display the current temperature.
The heating function is only possible with the optional heating control module.
APD main menu:
Select function
Current temp=23°C
Setpoint= 27°C Press these keys to set the desired setpoint for heating.
The heating function is only possible with the optional heating control module.
Trigger Display Description
Stop
inching
vor
inching
zurück
Reset
Gas
Ventil ein
1
Gas
Ventil aus
2
ist
Heizung
4
plus
Heizung
5
minus
Heizung
6