Abicor Binzel iROB Feed HA, Руководство по эксплуатации

Страница: 63 / 92

iROB Feed HA 7 Operation
BAL.0737.0 • 2019-11-15
EN - 17
7.2 Setup
The setup process can be used to set additional parameters so that the welding system can be operated optimally and with
greater precision. The setup parameters are assigned to a welding parameter. Each has its own number. Proceed as follows:
1 Press the main controller for five seconds.
2 Turn the main controller until the number of the desired parameter is displayed.
3 Press the main controller to display the values for the selected parameter.
4 Turn the main controller until the desired value appears.
5 Press the main controller again to exit the settings.
6 Turn the main controller until the parameter “0” appears “Save and exit”.
7 Press the main controller to exit setup.
7.2.1 Selecting the characteristic
1 Pressing opens the following display.

13.4 Synergy parameters on page EN-31
7.3 Program menu
Up to 64 welding programs can be saved and managed in the program menu. The menu is set up as follows:
1 Wire diameter
2
Wire diameter selection
3 Wire/gas selection
4
Combination selection
5 Syn. on/off selection
6
Existing characteristics
Fig. 9 Selecting the characteristic
1
2
3 4 5
6
1 Header area
2 Number of selected program
3 Function row 4 Main parameter of
selected program 5 Name of selected program
Fig. 10 iROB Feed HA , program menu
2
1
3
4
5