Abicor Binzel ABITIG GRIP Series, Руководство по эксплуатации

Страница: 18 / 44

EN - 8
5 Operating elements TIG welding torch
5 Operating elements
Using a standard welding torch, the two-cycle mode of the trigger can be
activated.
5.1 Trigger 2-cycle function
1 Press the trigger on the handle and keep it pressed = welding is started.
2 Release the trigger = welding is stopped.
6 Operation
1 Open the shielding gas cylinder and start the welding process.
2 After ignition, hold the welding arc near the surface of the material to be
welded until a molten pool is formed.
3 Move the torch uniformly over the entire seam length.
4 Stop the welding process.
5 After switching off, hold the torch over the end position for a few seconds.
This allows the molten pool to solidify without atmospheric interference
under the protection of the gas which is continuing to flow.
7 Putting out of operation
1 Switch off power supply.
2 Close the valve of the shielding gas cylinder.
NOTICE
• As the TIG welding torch is integrated into a welding system, the
operating instructions of the welding components, such as welding torch
and power supply, must be observed during operation.
WARNING
Electric shock
Equipment parts are energized in the enterprise.
• Do not reach into the danger zone.