Abicor Binzel ABI-CAR E-1200, Инструкция по эксплуатации

Страница: 58 / 68

EN - 26
BAL.0647.0 • 2018-08-24
8 Decommissioning ABI-CAR E-1200 / E-1200-O
7.2.3 Continuous welding
It is possible to perform continuous welding with the welding tractor. Observe the instructions in the following sections,
depending on the model you are using:

7.2.1 ABI-CAR E-1200 on page EN-25

7.2.2 ABI-CAR E-1200-O on page EN-25
1 Move the wire feeder, welding power source, and power supply cables as needed.
7.2.4 End crater filler function

Fig. 6 Connection setup (system illustration) for ABI-CAR E-1200 on page EN-15

Fig. 7 Connection setup (system illustration) for ABI-CAR E-1200-O on page EN-15
1 Set the 4-cycle mode at the welding power source (depends on manufacturer).

Fig. 15 Control elements 1200 on page EN-21

Fig. 16 ABI-CAR E-1200-O control elements on page EN-22
2 Push the Welding mode selection switch for ABI-CAR E-1200 (3) or ABI-CAR E-1200-O (8) into the up position
(crater filling) until the end crater of the welding seam is sufficiently filled.
7.2.5 Welding with the pendulum function (oscillator) (ABI-CAR E-1200-O only)

5.1.1 Pendulum function (oscillator) (with ABI-CAR E-1200-O only) on page EN-13
We recommend the following sheet thickness parameter settings for the workpiece to be welded:

Fig. 16 ABI-CAR E-1200-O control elements on page EN-22
1 To stop the welding tractor, push the START/STOP switch (5) down.
2 Press the Pendulum delay time knob (1) until the desired position (L/R/C) appears.
3 Turn the Pendulum delay time knob (1) until the desired delay time appears.
4 Turn the Pendulum speed knob (2) until the desired pendulum speed is achieved.
5 Turn the Pendulum angle knob (3) until the desired pendulum angle is achieved.
6 Set the desired speed with the knob (4) .
7 Set the direction of movement with the switch for adjusting the direction of movement (6) .
8 To start the welding tractor, push the START/STOP switch (5) up.
8 Decommissioning
1 Wait until the shielding gas post-flow time has passed.
2 Close the shut-off valve for the gas supply.
3 Switch off the power source.
4 Disconnect the welding tractor from the power supply (pull out the power plug).
Sheet thickness Pendulum speed Pendulum angle Delay time right/left
6 4–5 1–2 0.1–0.2
8 5–6 1–2 0.2–0.4
12 7–8 1–2 0.3–0.6
Tab. 9 Pendulum parameter options (recommended)
NOTICE
• When decommissioning the system, ensure that the procedures for switching off each of the welding tractor
components are observed.