Disclaimer: Products in this manual must by law be installed by licensed and registered tradespeople in accordance with the relevant standards. ABI and the manufacturer/distributor reserve the right to
vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. The information listed is correct at the time of publication, however ABI and
the manufacturer/distributor takes no responsibility for printing errors. Copyright © ABI Interiors 2022.
Note:
Dimensions are nominal measurements only
SPECIFICATIONS
RECOMMENDED USE
MATERIAL
TEMPERATURE RATINGS
PRESSURE RATINGS
SUITABLE FOR HOT WATER UNITS
COMMERCIAL PULL OUT SPRAY ATTACHMENT
Domestic
304 Stainless Steel
Maximum continuous working temperature 75
o
C
If the water exceeds 75
o
C, an approved temper -
ing valve must be fitted
Recommended minimum working pressure 0.2 Bar
Recommended maximum working pressure 5 Bar
Hot and cold water inlet pressure should be equal
Storage tank: Yes
Continuous flow: Yes
Gravity fed system: Not Suitable
n
n
n
n
AS/NZS 3718:2005
WM-022852
