Step 1.
Step 2.
Insert the silicon
edge of the fabric
into the groove of
the extrusions.
Start on the corners,
then centers and work
your way to corners from
center on both directions.
To pull fabric graphic out
of extrusion groove, use
pull tab on corner
2. GRAPHIC
4. WALL MOUNT
(Optional)
Attach wall bracket
to top extrusion
groove with provided
hammerhead screw.
Locate position of wall
bracket on extrusion
(preferably by wood stud) by sliding the
bracket on the extrusion and tighten it.
Secure the frame to the wall with provided
wood screw.
LW-34 PACKAGE CONTENTS
Extrusion fabric groove
fabric graphic
w/silicon edge
Step 3.
1. Slide corner connectors (Z965) into both sides
of horizontal extrusions.Turn each screw
enough to hold connector in place.
2. Slide vertical extrusions onto corner connec-
tors of top horizontal extrusion. Turn each
screw enough to hold connector in place.
3. Finish frame assembly by sliding corner
connectors of bottom horizontal extrusion on
to vertical extrusions and tighten the screws to
secure frame extrusions together.
Tighten both screw
firml
y.
Loosen the screws on base
plate
but
do not
remove
them.
Than
swivel
base
plates.
Bottom view
Bottom view
3. LIGHT ASSEMBLY
Lights come attached to extrusions. Ensure all lighting strips are connected. Once frame is assembled,
connect strip-to-power cords to the end of top and bottom lights chain.
- For bottom lights connect strip-to-power cord to power supply directly.
- For top lights connect extension cord to strip-to-power cord and run with wire managment extrusion then
connect to power supply.
Run AC power cord out through grommet hole on vertical upright and connect to power outlet.
To remove or re-attach light strips use provided thumbscrews with plate
Strip-To-Power Cord
EXtension Cord 12ft
PACKING DIAGRAM
001
001
002
003
005
004
Z965 - Corner Connector (2)
Power
Supply
Wire
Managme
nt Ho
l
e
Pro
fi
le
Label
001
Description
1/4" ALUMINIUM OVAL BASE PLATE 17.5" (444.5MM) x 4.72" (120MM)
#
2
002
003
M1901 36" (914.4MM) EXTRUSIONS W/ (2) 45° CUTS, (4) HOLES FOR BASE PLATE & LIGHTS
M1901 47.5" (1206.5MM) EXTRUSIONS W/ (2) 45° CUTS
1
1
004
M1901 47.5" (1206.5MM) EXTRUSIONS W/ (2) 45° CUTS & POWER SUPPLY
1
8
Z966 90° CORNER INTERNAL CONNECTOR
5/16-18 FLAT HEAD SCREW 0.75" LONG FOR BASE PLATES
4
2
35.5"W (908MM) x 47"H (1194MM) SINGLE SIDED DYESUB GRAPHIC W/ SEG WELT ALL 4 SIDES
005
M1901 36" (914.4MM) EXTRUSIONS W/ (2) 45° CUTS & LIGHTS
1
INSTRUCTIONS / ASSEMBLY
ABEX EXHIBITS • ABEX.COM • 355 PARKSIDE DR. SAN FERNANDO, CA 91340 • (800) 537-0231
3ft x 4ft
