Abekas AirCleaner, Руководство пользователя

Страница: 76 / 106

66 AirCleaner • User Guide
4. Operations
Programming AirCleaner
Programming AirCleaner
This section describes the basic operation of the control panel found on the front of
the AirCleaner chassis.
Control Panel Basics
The AirCleaner control panel consists of two rotary knobs (each with an integrated
push-button) and an illuminated two-line LCD, as shown below.
Figure 4-28. AirCleaner Control Panel user interface
In the vast majority of operations, the information shown in the LCD has the
following structure:
•
TOP line: Displays the active menu parameter
•
BOTTOM line: Displays the value of the active parameter
Of course there are exceptions to this rule, but for the most part this is the format of
the information shown in the LCD. For example, the information in the following
display:
...shows the active menu parameter
Total PGM Delay
(Total Program Delay)
with the value of this parameter set to “
8:15
” (eight seconds, fifteen frames).
In the vast majority of operations, the two rotary knobs are used as follows:
•
SELECT
rotary knob: Turn to select parameters within the active menu.
•
SET
rotary knob: Turn to adjust parameter values for the menu item that
is currently active.
Adjusting Parameter Values
The
SET
knob is always used to adjust parameter values. Whenever a given
parameter is active in the LCD, turning the
SET
knob clockwise and/or counter-
clockwise will adjust the value for the active parameter.
In the example menu shown above (for Total PGM Delay ) turning the
SET
Total PGM Delay
8:15