1.FUNCTIONS & FEATURES
2.PRECAUTIOMS
3.KNOW ABOUT THIS RADIO
4.HOW TO USE THIS RADIO
2.1
You are adviced to check radio version first before connect power cable:
◆
12V version radio
: Your radio must be supplied with a continued current
of 12 volts.
2.2
Please install the antenna (connect to the location“B”on the back panel
of the radio) and set the SWR (Standing Wave Ratio) before transmitting.
Failure to do so may result in destruction of the power amplifier, which is
not covered by the guarantee.
◆
AM and FM mode
◆
VOX
◆
CTCSS/DCS
◆
VOX
◆
SQ and ASQ Control
◆
Full Channel SCAN
◆
EMG Channel CH9/19
1
2
3
4.1
Power On/Off the Radio
....................................................................
(1)
Turn VOL knob
clockwise to power on the radio, the LCD displays
channel number.
(2)
Turn VOL knob
anti-clockwise, until hear "Ka Ta", the radio is
powered off.
4.2
Volume Control
...................................................................................
Turn VOL knob
clockwise to increase volume, anti-clockwise to decrease
volume.
4.3
ASQ / SQ Control
...............................................................................
※ASQ
(Automatic Squelch Control)
Turn SQ knob
anti-clockwise into ASQ position. LCD displays "
". No
repetitive manual adjustment and a permanent improvement between the
sensitivity and the listening comfort when ASQ is active. This function can
be disconnected by turning the switch clockwise. In this case the squelch
adjustment becomes manual again. "
" disappears from LCD.
※SQ
(Manual squelch)
Turn the SQ knob
clockwise to the exact point where all background
noises disappear. This adjustment should be done with precision as, if set
to maximum (fully clockwise), only the strongest signals will be received.
4.4
▼CH/▲CH
...........................................................................................
※Channel Selector
(short press)
(1)
These keys allow increasing or decreasing a channel. A beep sounds
each time the channel changes.
(2)
Hold
or
can fast change working channel.
※Scan
(very long press)
(1)
Press and hold the
or
key for 7 seconds or until a beep sounds
to start scan function, LCD displays "
".
(2)
Short press
or
key to change scan direction during scan.
(3)
Short press
or [
PTT
] key to exit scan function.
3.1
Function location
CB RADIO
Instruction Manual
1
4
5
3
7
6
8
10
9
C
B
D
A
2
1
POWER ON/OFF ~ VOLUME CONTROL
2
SQUELCH~ASQ (Automatic Squelch Control)
3
MICROPHONE JACK
4
LCD
5
MODE ~ KEYPAD LOCK
6
CTCSS/DCS ~ CTCSS/DCS SET
7
EMERGENCY CHANNEL ~ RESET
8
CHANNEL SELECTOR
9
CHANNEL SELECTOR
10 VOX ~ VOX SET
A ANTENNA JACK
B EXTERNAL SPEAKER JACK
C POWER CONNECTION
D PTT SWITCH
R
AR-M6
