CentriMag
TM
Circulatory Support System Operation Manual (US)
Page 53 of 126
© 2019 Abbott – Document No PL-0047, Rev 11 (December 2019)
Figure 21: Mounting of Two Consoles onto System Cart
WARNING
Only use the Standoff Distance Holder and the Standoff provided by the
supplier. Use of any other component may result in a sudden Motor stop.
7.3 Monitor Mounting
7.3.1 If the Console is intended to be used with the Monitor, the Monitor must be
securely fixed to a solid object. This can be achieved with the Monitor Arm
provided by Abbott Medical and Ergotron. The Monitor Arm can be mounted
either on the edge of a horizontal or vertical solid surface or on a vertical
pole. For instructions on how to set-up the Monitor Arm refer also to the
manual provided by Ergotron. Steps required to set-up the Monitor Arm:
1. Mount the Monitor Arm Clamp on the adapter plate:
illustrates the two
possibilities for mounting the clamp on the adapter plate. If the Monitor Arm is to be
mounted on the edge of a vertical surface or a vertical pole, the clamp has to be
mounted as shown in part A of
. If the Monitor Arm is to be mounted on the
edge of a horizontal surface, the clamp has to be mounted as shown in part B of
. Make sure that the oval end of the adapter plate is on the screw side of the
clamp in the latter case.