Abbott CELL-DYN 3200, Руководство оператора системы

Страница: 255 / 684

CELL-DYN ® 3200 System Operator’s Manual
5-103
9140181H—October 2001
Section 5 Operating Instructions
Using The Work List
Introduction
The Work List is used to pre-assign sample identification and display and print
criteria for samples that will be run. It is essentially a list of samples (including the
pre-assigned information) that the operator intends to run on the instrument. Work List
entries may be downloaded from a host computer to the CELL-DYN 3200 System,
or the entries can be made by an operator at the instrument.
This section will provide an overall review of the Work List, discuss the
WORK LIST
menu and
WORK LIST SET UP
menu, and discuss the procedures for running
samples under the following conditions:
1. Work List records with Bar Codes in the <Specimen ID> field are
downloaded from the LIS.
2. Work List records with other sample identification (non Bar Code) in the
<Specimen ID> field are downloaded from the LIS.
3. Work List records with Bar Codes in the <Specimen ID> field are entered at
the instrument by the operator.
4. Work List records with other sample identification (non Bar Code) in the
<Specimen ID> field are entered at the instrument by the operator.
As samples are processed, the Work List is accessed. If the identifying information
on the sample, such as a bar code number, matches the identifying information of
an entry in the Work List, then a “match” has occurred and that entry is removed
from the Work List. The demographic data and the results of the sample run are
displayed on the
581
screen and stored in the Data Log. The demographic data is
also included on the printed report.
The Work List can accept a specimen identifier other than a bar code in the
Specimen ID field. However, since both models come equipped with a bar code
reader for the Closed Mode, it is expected that bar code numbers will be the
preferred method for identifying samples.
The following bar code symbologies may be used in the <Specimen ID> field:
• Code 39, Code 128, Interleaved 2 of 5, and Codabar
NOTE: Refer to Appendix A for complete information on the use of bar
code labels.
NOTE: The number on bar code labels must be greater than 2 digits to
avoid possible confusion by the bar code reader with the 2 digit bar
code label on the racks.