ABB Terra 94 UL, Руководство по эксплуатации и установке, Страница: 14 / 90

14 “Operation and installation manual” - “Terra 94/124/184(NEVI) UL”
EN
2.5 Safety instructions
• Only perform the procedures as indicated in this document.
• Only perform any services as installation engineer or use the EVSE when you are fully qualified to do so.
DANGER
If and to the extent permitted by law, in case of inconsistency or contradiction, between any
requirements or procedure contained in this document and any such local laws and/or rules,
comply with the stricter laws and/or rules, requirements and procedures specified in this
document.
2.5.1 Safety instructions during transport
• Put on the correct personal protective equipment.
• Make sure that the hoisting equipment or forklift truck can lift the EVSE
safely.
• Take into account the mass and the center of gravity of the EVSE.
• Obey the applicable safety instructions for the hoisting equipment or for the
forklift truck. For example, the instructions specified on the related shipment
label that is applied to the EVSE packaging.
2.5.2 Safety instructions during installation
• Put on the correct personal protective equipment.
• Make sure that there aren’t any supply voltages on the input cables during the
complete installation procedure.
• Keep unqualified personnel at a safe distance during installation.
• Only use electrical wires of sufficient gauge and insulation to handle the
rated current and voltage demand.
• Make sure that the load capacity of the grid is in accordance with the EVSE.
• Make sure that the wiring inside the EVSE is protected from damage and
cannot get trapped when you open or close the EVSE.
• Do not open any covers/doors of the equipment in case of adverse climatic
conditions. Infiltration of water or sand and presence of high humidity can
cause damage of the equipment. It is of paramount importance to evaluate
the weather conditions in the risk assessment prior any intervention on the
equipment.
• Protect the EVSE with safety devices and measures that the local rules
specify.
• Make sure that the EVSE is connected to a Protective Earth (PE).
• Make sure that the connections to the EVSE comply with all applicable local
rules.
Additional instructions during ground works
• Make sure that the equipments used during ground works are certified.
• Comply with all applicable local rules.
2.5.3 Safety instructions during cleaning or maintenance
• Put on the correct personal protective equipment.
• Make sure that there isn’t any supply voltages on the input cables during the
complete cleaning or maintenance procedure. Refer to section “9.3. Total de-
energization of the EVSE”
• Keep unauthorized personnel at a safe distance during cleaning or
maintenance.
• If for cleaning or maintenance it is necessary to remove safety devices,
immediately install the safety devices after the work.