Setup pages
67
Dial-up/GPRS/Ethernet failover settings
In this section you find configuration to allow SREA-01 to connect to Internet using a
modem.
Dial Up
- Specifies the dial-up settings disable/enable. With Ethernet failover to
modem selection the SREA-01 communicates to Internet over wired Ethernet and
changes to modem communication in case of the Ethernet communication to
Internet is lost. After recovery of Ethernet communication the modem
communication is terminated. Refer to Connection time before restoring to Ethernet.
Connection trigger
– Specifies whether SREA-01 should always be connected to
Internet using the modem, or only connect when there is an alarm or event.
Connection time before restore Ethernet
- Setting until the permanent modem
connection in case of fail in Ethernet communication is terminated after re-
establishing the Ethernet communication.
Содержание SREA-01
