SM3000
Multipoint Videographic Recorder
4 Operation
IM/SM3000–EN Rev. L
19
Note.
Applicable only to Circular Chart view.
Stop and start individual totalizers.
Channel totalizers that have not been enabled in the Configuration level are greyed-out.
Note.
When a totalizer is not running (i.e. 'Stop' is selected), the corresponding totalizer
value is shown in red.
Note.
Applicable only to Circular Chart view.
Reset the totalizer value to the totalizer preset value.
Channel totalizers that have not been enabled in the Configuration level are greyed-out.
To acknowledge a particular alarm, use the
and
keys to highlight it in the menu
and press the
key.
Note.
Active unacknowledged alarms in the current process group are identified by a
red border around the value in the associated channel indicator, alternating with a red
Alarm Event icon in the bottom left hand corner of the same indicator. Active
acknowledged alarms are identified by a continuous red Alarm Event icon in the bottom
left hand corner of the indicator – see Fig. 4.3, page 10.
To acknowledge all active alarms in the current process group simultaneously, select 'All'
and press the
key.
Note.
If an alarm in another process group is active, the Global Alarm status icon (
)
continues to be displayed in the status bar. If an active alarm in another process group is
unacknowledged, the icon is surrounded by a red flashing border (
).
The short channel tags of individual alarms that have not been configured are greyed-out
in the menu.
Select 'AutoView Scroll' to display the enabled chart view for each configured process
group in turn for 40 seconds. The AutoView Scroll status icon (
) is displayed in the
status bar when AutoView Scroll is active. Press any key to cancel AutoView Scroll.
Note.
Applicable only to Circular Chart view.
Select to start a new circular chart.