ABB Sensyflow FMT700-P, Руководство по эксплуатации

Страница: 26 / 50

Communication
26 Sensyflow FMT700-P 42/14-42-EN
Pos: 15.9 /Kommunikation/Durchfluss/FMT700-P/Befehlsliste @ 33\mod_1253169204578_3101.doc @ 301763 @ 4
6.1.1.3 Command list
Enter the command XB
CR
to access the command list.
When a monitor is connected, the following text appears:
CLS
Command list
Command Description
<XR> Reset supply / evaluation unit
<XTT> Transmits general information
<XB> Transmits interface command list
<XF> Transmits error table
<XS> Constantly transmits flowrate in selected unit
<XH> Stops <XS> output and enables interface
<XE> Only one measured value is transmitted
<XA> Transmits totalized mass / standard volume in g/l once the stop bit has been
set (externally triggered)
<XZ> Measuring rate change for display and analog out
Example: <XZ0100
CR
>; <XZ0005
CR
> !!! 4-character cycle number must be
used
<XSR> Requests the set SAMPLE RATE
<XU0> Selects first unit: kg/h
<XU1>
Selects second unit: e.g., m
3
N/h
<XSW1> Switches sensor 1 to supply / evaluation unit
<XSW2> Switches sensor 2 to supply / evaluation unit
<X$> Transmits length of individual strings
<XTR> Transmits most recently measured temperature value.
If no transmitter is connected, E 11 appears on the display;
in the event of a Pt100 sensor break: E 12
<XT1> Switches temperature measurement sensor 1, value transmitted via <XTR>
<XT2> Switches temperature measurement sensor 2, value transmitted via <XTR>
Sensor / Transmitter = flowmeter sensor
Pos: 15.10 /======= Seitenumbruch ======== @ 0\mod_1126532365768_3101.doc @ 3830 @