![background image](http://html.mh-extra.com/html/abb/sace-tmax-xt5/sace-tmax-xt5_operation-and-maintenance-manual_2240026.webp)
ABB | SACE Tmax XT
24 | © 2019 ABB | 1SDH002039A1002 - ECN000093027 - Rev. A
Interface and menus | 1 - Presentation of interface
LEDs
LEDs
Colour
Description
Power
Green
Indicates the on status of Ekip Touch:
• off: no power and unit off
• on, steady (
Power mode
) or flashing (
Alive mode
): unit on and self-supplied by
external
Vaux
or service connector
The
Power mode
or
Alive mode
can be selected via Ekip Connect: if the
Alive mode
has been selected and external modules are connected, the Power leds of Ekip
Touch and the modules flash in the synchronized mode.
More details are given in the chapter on Ekip Connect additional functions on page
119
Warnings
Yellow
Signals that certain alarms are present:
• off: no alarm
• on steady: prealarm of an active protection or status contacts error
• two flast flashes every 0.5 s: trip unit parameter configuration error
• fast flash:
Rating Plug
or
Ekip Measuring
module installation error
Alarm
Red
Signals that an alarm is present:
• off: no alarm
• on steady: on steady signals a TRIP due to a protection
• two flast flashes every 2 seconds:
Rating Plug
error
• on with fast flashing: protection timing tripped or alarm due to disconnection of a
current sensor
If on and flashing at the same time, the Warning and Alarm leds signal an alarm caused by a hardware error
inside the Trip unit.
This case requires assistance from ABB.
Push-buttons
Push-
button
Description
HOME
Allows different areas of the menu to be accessed:
• from pages:
HOME, Histograms, Measuring instruments, Measurements, Main
measurements
-> open:
Main page
• from pages:
Main page, Alarm list
, at any point of the menu area -> open:
HOME
page
iTest
Allows certain pages of information about the unit to be rapidly consulted; press the button
in successionj to display the following pages:
•
Alarm list
, if messages are present
•
Info
, if Customer Page option is active (page 119)
•
Protection unit
, with information about Ekip Touch
•
Circuit breaker
, with information about the CB
•
Last trip
, with information about the last trip, if available
Consultation is active from pages:
HOME, Histograms, Measuring instruments,
Measurements, Main measurements
NOTE
:
with Ekip Touch off and the internal battery charged, press
iTEST
to
temporarily switch on the Power led and, in the case of a trip, the display with
information about the trip protection and the Alarm led
Service connector
The service connector enables Ekip Touch to be connected to
Ekip TT
,
Ekip T&P
and
Ekip Programming
,
allowing the unit to be temporarily supplied, parameter configuration prior to putting into service, tests and
extension of the configuration functions.
IMPORTANT: only use cables supplied by ABB or with ABB accessories
Содержание SACE Tmax XT5
Страница 2: ...ABB SACE Tmax XT 2 2019 ABB 1SDH002039A1002 ECN000093027 Rev A ...
Страница 4: ...II 2019 ABB SACE Tmax XT 1SDH002039A1002 ECN000093027 Rev A ...
Страница 204: ...ABB SACE Tmax XT 202 2019 ABB 1SDH002039A1002 ECN000093027 Rev A Other accessories 5 Testing and Programming ...
Страница 205: ...1SDH002039A1002 ECN000093027 Rev A ...