ABB RELION REX640, Техническое руководство, Страница: 1323 / 1960

In the example, the incoming feeder is carrying a load of 2.0 pu and both outgoing
feeders carry an equal load of 1.0 pu However, both HIxPDIF and HZCCxSPVC
consider the current as an increased differential or unbalance current because of
the broken CT wire in phase C. Both HIxPDIF and HZCCxSPVC receive the differential
current of approximately 1.0 pu The main differential protection HIxPDIF cannot
operate because of the higher current setting.
All CTs must have the same ratio.
The
ALARM
output of the CT supervision function can be used to energize an
auxiliary relay which can short-circuit the current CT wires, making the busbar
differential protection inoperative. This arrangement does not prevent unwanted
operation of HIxPDIF if the start setting is below the rated load. For example, if
the start setting for HIxPDIF in the example is set as 0.8 pu HIxPDIF operate before
HZCCxSPVC.
6.3.8 Signals
6.3.8.1 HZCCASPVC Input signals
Table 1254: HZCCASPVC Input signals
Name Type Default Description
I3P SIGNAL - Three-phase currents
BLOCK BOOLEAN 0=False Block signal for acti-
vating blocking mode
6.3.8.2 HZCCBSPVC Input signals
Table 1255: HZCCBSPVC Input signals
Name Type Default Description
I3P SIGNAL - Three-phase currents
BLOCK BOOLEAN 0=False Block signal for acti-
vating blocking mode
6.3.8.3 HZCCCSPVC Input signals
Table 1256: HZCCCSPVC Input signals
Name Type Default Description
I3P SIGNAL - Three-phase currents
BLOCK BOOLEAN 0=False Block signal for acti-
vating blocking mode
1MRS759142 F Supervision functions
REX640
Technical Manual
1323