ABB RELION REL670, Руководство по установке и пусконаладке

Страница: 62 / 198

54
Entering settings Chapter 8
Establishing connection and
verifying the
1 Entering settings
If the IED is connected to a monitoring or control system via the rear SPA/IEC port, the
SPA/IEC port has to be set either for SPA or IEC use.
1.1 Entering SPA settings
When using the SPA protocol, the rear SPA/IEC port must be set for SPA use.
The SPA/IEC port is located at IED X310 on the rear side of the IED. Two types of interfaces
can be used:
• for plastic fibres with connector type HFBR
• for glass fibres with connectors type ST
Procedure
1. Set the operation of the rear optical SPA/IEC port to “SPA”.
The operation of the rear SPA port can be found on the local HMI or in
the PCM at:
Settings\General settings\Communication\SLM configuration\Rear optical SPA/IEC
port\Protocol selection SPA or IEC 103
When the setting is entered the IED will automatically restart. After the
restart the SPA/IEC port operates as a SPA port.
2. Set the slave number and baud rate for the rear SPA port
The slave number and baud rate can be found on the local HMI at:
Settings\General settings\Communication\SLM configuration\Rear optical SPA/IEC
port\SPA
Set the same slave number and baud rate as set in the SMS system for the
IED.
1.2 Entering IEC settings
When using the IEC protocol, the rear SPA/IEC port must be set for IEC use.
The SPA/IEC port is located at IED X310 on the rear side of the IED.
Two types of interfaces can be used:
• for plastic fibres with connector type HFBR
• for glass fibres with connectors type ST